Bulk high - speed traveling wave e - o modulator was also fabricated , the half - wave voltage is just 760 v , response time of the device is low up to 297 ps 此外,用本實驗的ktp晶體制作了體式高速行波電光調制器,半波電壓760v ,脈沖響應時間快到297ps 。
Finite element method ( fem ) is a method that is efficient in electromagnetics . for the first time the thesis applied vectorial fem to single mode performance and half - wave voltage analysis and design 有限元法被廣泛應用于電磁場的研究中。本論文首次采用了矢量有限元方法來研究質子交換鈮酸鋰光波導的單模特性和半波電壓。
In order to realize low half - wave voltage , high polarzation extinction ratio , low pigtailing polarization crosstalk , low insert loss , precise tapped power ( ratio ) and good splitting beam ratio , the optimum design was performed 為了實現低的半波電壓、高的偏振消光比、低尾纖串音、低插入損耗、精確的抽頭功率比和良好的分束比,我們對器件結構進行了優化設計。
Because of the limitation of the measuring condition , in the thesis we had only measured some characteristics of the phase modulator : channel waveguides " loss coefficient is 0 . 22db / cm , the split - ratio is 52 / 48 and half - wave voltage is < 5v 由于條件所限,論文中僅測量了直波導損耗系數、相位調制器的半波電壓和輸出分束比。經測量,半波電壓小于5v ,直波導損耗系數為0 . 22db cm ,輸出分支比為52 48 。